Screen Enclosure and Fence Cleaning West Palm Beach

Screened pool cages and lanais are a defining feature of South Florida homes, and the same humidity that grows algae on a driveway grows mildew on the mesh, the frame, and the fence line around it. Screen Enclosure and Fence Cleaning covers pool cages, lanai screens, and vinyl, aluminum, and wood fences across West Palm Beach and Palm Beach County, using a soft wash approach that removes the growth without tearing mesh, scratching finishes, or forcing water into joints.

Why Screens Need Low Pressure

Screen mesh is thin and held in place by a rubber spline, so a high pressure nozzle can stretch the mesh, tear it, or push the spline out of its channel. A soft wash applies a cleaning solution at low pressure, lets it work on the mildew, pollen film, and dirt, and then rinses from the top down so loosened grime does not run across a section that is already clean.

The result is a cage that looks clearer and lets more light and air through, without a screen repair afterward. Screens that are already torn or brittle from age should be assessed first, since any cleaning method will stress them.

Fence Cleaning by Material

Vinyl fencing cannot mold on its own, but the pollen, dirt, and moisture that collect on the surface give mold and algae something to grow on, which is why shaded, north facing sections turn green first. Vinyl tolerates more pressure than wood, but a narrow zero degree tip can scratch or gouge it, and water should not be forced into the joints where panels meet posts. A soft wash approach stays well under what the material can take.

Wood fencing is softer than vinyl, and the same guide puts its pressure limit lower, around 2,000 PSI. In practice a gentler soft wash is safer on wood, because high pressure raises the grain and leaves a fuzzy, uneven surface. Aluminum fences with a coated finish should be washed with a mild solution and low pressure, since abrasive methods can dull or wear through the coating.

Salt Air, Aluminum Frames, and Storm Checks

Screens collect pollen, dirt, algae, and salt, which weaken the material over time, and salt in the air speeds up oxidation on aluminum frames. A chalky feel on the frame means the protective finish has started to deteriorate. Homes closer to the coast, as across much of eastern Palm Beach County, are the most exposed. Cleaning removes the buildup that holds moisture against the metal, but it cannot restore a failed finish, which is a job for recoating.

The same source warns against high pressure washers on enclosures because they can damage mesh fibers or force water into connection points, which is the reason for the low pressure method described above. It also recommends checking fasteners, connection points, and roof panels for rust or movement, especially after storms. We clean the surface, so anything that looks loose, rusted, or bent should go to an enclosure contractor before or after a wash.

Cleaning Order Matters Around a Pool

When a pool cage, a paver deck, and a fence all need work, the order matters. Screens and the cage frame are cleaned first and from the top down, so runoff does not fall onto surfaces that were just finished, and the deck and fence line are cleaned last. This is the same sequence used on our paver and patio cleaning work, and it is why combining services into one visit tends to leave a cleaner finish than cleaning each surface in isolation.

Before and After

Before

After

Before

Before

After

After

A screened pool enclosure from one of our jobs. The deck inside the cage was dark and stained before cleaning and looked far brighter afterward, and the screens and roof panels came clean too.

Signs Your Screens and Fences Are Due

A gray, green, or dusty tint across screen mesh is usually the first sign, especially on the side of a cage that gets the least sun. Dark mildew in the lower corners of the frame, green streaks on the shaded north facing sections of a vinyl fence, and a powdery film that comes off on your hand are all signs that growth has built up past what a rinse will remove. Catching it at that stage keeps the job a gentle soft wash instead of a restoration.

What Screen Enclosure and Fence Cleaning Covers

• Pool cage and lanai screen cleaning, including screens, frames, and tracks
• Vinyl fence cleaning to remove algae, mildew, and pollen film
• Aluminum fence cleaning with a low pressure method that protects the finish
• Wood fence soft washing that avoids raising the grain
• Pair it with paver and patio cleaning for the deck around the cage
• Pair it with house and stucco soft washing for the walls the screens attach to
• Pair it with window and gutter cleaning for the glass behind the screens

How Often Should Screens and Fences Be Cleaned?

Screens and cage frames typically need cleaning every six to twelve months in West Palm Beach, closer to six where trees, shade, or a nearby waterway keep them damp. Vinyl fences follow the twice a year guidance above, while aluminum and wood fences generally hold up with an annual wash unless visible mildew returns sooner.

Frequently Asked Questions

Screens, cage frames, and fences each need a different touch to clean without damage, and a quick look at the actual materials on your property is the best way to get the method and the price right. Request a free on site estimate and get a plan built around what you have. For a full breakdown of every service, see the complete pressure washing guide. We also serve Palm Beach Gardens, North Palm Beach, Palm Beach Island, and Boynton Beach, and if you want real cost ranges before booking, see our 2026 pricing guide. For wooden decks, see our wood deck cleaning page.